What are the tunable parameters for the Unison Double Tracker? [ANSWERED!]

[darwin999]

Would someone tell me what the tunable parameters are for the 3 modes of the Unison Double Tracker PCB?
I.e.,

• for Mode #1 = Dual Detune, what are the tunable parameters 1, 2 & 3?
• for Mode #2 = Modulated, what are the tunable parameters 1, 2 & 3?
• for Mode #3 = Double Take, what are the tunable parameters 1, 2 & 3?

All I'm looking for are the NAMES of the tunable parameters for each mode.
Having them listed in one place would be very helpful for me, as well as others looking into the Unison PCB.
Thanks in advance!!!

 

[Robert]

They're listed on the page for the EEPROM Builder.

EEPROM Builder - PedalPCB.com

Custom Programmed EEPROM

www.pedalpcb.com

I agree, this definitely should be on the Unison page as well.

ALGORITHM	CONTROL 1	CONTROL 2	CONTROL 3

UNI001 - Unison (Dual Detune)	Detune 1	Detune 2	Time
UNI002 - Unison (Modulated)	Mod Rate	Mod Depth	Time
UNI003 - Unison (Double Take)	Detune 1	Detune 2	Time

 

[darwin999]

@Robert - THANK YOU!!!

 

[jcpst]

Excellent, this is what I was looking for. One more question: do you happen to know the ms range on the TIME parameter?

 

[darwin999]

Excellent, this is what I was looking for. One more question: do you happen to know the ms range on the TIME parameter?

Good question, I'm not sure, but it's surely set by the FV-1 so check out the various docs at http://spinsemi.com/products.html
Looking at the application notes (http://spinsemi.com/Products/appnotes/spn1001/AN-0001.pdf) the clock is normally set to 32767 Hz, and delays *appears* to be programmable from integer N=1 to 32767...

 

[jcpst]

That’s pretty interesting, though I suppose what I was asking would be a question for @Robert

I was just curious how much delay is available for TIME in those Unison algorithms, e.g. 40ms, 60ms,