cooder

It does look like a nice neat one!

I made a couple of mods, adding a FAT switch and a CLIP switch. At this point, I'm calling it done. Q1 can be any medium-gain Si NPN...

This was inspired by Music6000. He sent me pix of a pedal he bought called the Canaglia and a link to a schematic on FSB. A simple...

Great stuff, great butchery there. So how do you like this incarnation compared to the Joe Bonemassa wah and the Ernie Ball and other...

I have dived into a rabbit hole concerning wahs. I have an Ernie Ball wah that sounds a bit better than stock after some mods, I did a...

I woke up wayyyyyy too early, and didn't feel like a walk. A bit more spaghetti than I'd like, and had to move two supply wires to the...

Anyone consider making PCBs of this?

So how do know which taper to use? It really comes down to how the circuit responds when we turn the knob. For the most part, A-taper...

There are a lot of misconceptions floating around regarding pot tapers and parallel resistors, so I thought I'd make an attempt to...

In this part, we'll discuss what happens when we put a resistor in parallel with a pot. We'll address the simple case where we use the...