bluedmc777

Progress… fired up and biased.. gotta source some tiny screws for backplate

@Robert Will you please give these guys a peek at something top secret so we can move on!? 😂

This one gets by far the most use, but I have close to a dozen others too...

I actually have a T18-D24. I’ve always figured it’d be way too big for pcb work. https://a.co/d/0iMgO7Mn

I do love me a good MIAB. This is the newer one from Marshall. Built to the BOM except I used JRC4559 for the opamps. Funny story, I...

as discussed in one of @Ginsly ‘s threads about opamp muffs, i tried a few of them and none of them really seemed to be that exciting or...

Intruding upon the admin's workbench area and posting your bullshit upon it. 7 lashes and 3 hail santas.

Oh shit I didn’t even realize there’s 2 threads with damn near the same name! 😂. I hailed SANTA 3 times I’ll see if I can get the wife...

AANNDD you HAVE to put white washers on the outside of your next 5 builds. Like a DIY dunce cap.

What are my crimes there’s no white washers here.

I know this is an old thread and that I asked about tips in another thread but just came upon this one because I’m still struggling with...

Used a Vero layout from tagboard effects. 3d printed the enclosure and went to work getting it all in there… Turned out pretty good…...

No probs... Already had the label printed and sitting in box... Will ship out tomorrow.

5532s are 70¢ at the big box boys

5532 or any decently low noise spec dual 072 would work in a pinch. I don't think the cast iron is clipping the opamp at all so even a...