HamishR

Nice! I’ve been pretty happy with the father of the Beast, the Bee Sting 🐝. Looking forward to this one!

Is there ever anything to be gained (excuse the pun) by running two halves of a dual opamp in parallel?

I just built one with the marvellous Mr Szukalski's PCB. It sounds much as I remember my old Diablo sounding, which is a good thing...

Seems like the slide pots are going to be subject to a lot more shoe shrapnel with the stomp switch on top line that.

"The bypass switch is above the sliders to keep it out of the way of on-the-fly adjusting." Not because the footswitch wouldn't fit at...

Whoops - my bad! I wired it backwards originally in my build - sorry! As soon as I flipped the filter it works properly - I don't know...

Are you sure about the wiring of the Filter pot in your schematic? I had to swap pins 1 & 2 to get the pedal to behave like the clips...

I would just check continuity between all points where things can move. For example check that you are getting continuity at each end of...

This tells me that I'm doing the right thing by testing every single resistor before installing it. It doesn't take long and it's partly...

I suspect that your iron isn't quite hot enough. You should only need a second at most to make your solder connections, then they don't...

I use this pedal a lot. It's my favorite compressor. When I built this pedal I put the jacks on the side so that if I set up the pedal...

You could probably fit that into a 1590A.

This barely fledged little fella has been visiting our back yard the past few days. He's a laughing kookaburra, not a blue winged...

One thing I really admire about Chuck is how generous he is with his time. He is extremely patient with me who knows nothing about...

And that's how Matchless and Badcat do their logo plates. Dave that looks fantastic!