jcpst

Thanks! I like it too. Although with that design, it always looks crooked, no matter which way you rotate the enclosure

Looks good in the bit crusher

Could the power cables running between the electros and transistor be contributing to the noise floor?

I have a cycle of expanding my pedalboard, adding more sophisticated programmability along the way, and then I hit a threshold where...

Hello here! this is my second pedal "project": -Tayda 1590A Light Gold powder coating painted, Drilled, UV painted -Almost all...

I expected to like this circuit, so I took my time and used my favorite components (that I had on hand). No regrets, I love this thing...

From the placement of that capacitor, it looks like it's purpose is to block DC from going to the next gain stage. A 12nf will work...

Thanks @jwin615 !

Yes, yes Probably not very noticable. We're talking a quarter octave ish

I’m a hobbyist with almost no background in electronics, but I absorb some info from reading stuff on the forum. I wanted to see if I...

I've been making progress on my latest round of builds, but with most of them, I tend to stop once the PCBs are populated and save them...

Nice build. I don't think that being light on the lows was a mistake. A Rickenbacker bass into a marshall super bass with the tone...

Another way to get some PCBs of this width to fit in a 1590B is to solder just the tip of the pot legs into the PCB. I've done this...

Nice work. Cost? I tried something similar for small control labels as proof of concept but for me just using Amplifyfun to do UV prints...