falco_femoralis

I'd like to see this as I'm considering decals for my labels but idfk what I'm doing

Here's How I would do it. The blue lines represent the resistor leads, the green, your wire. Using an On/On switch each resistor will be...

Figured it might be worth asking, does anyone know what the Midas Touch mod for the Mad Professor Amber Overdrive entails? It sounds...

I'd love to see this too. The Amber OD is one of my favorite pedals and I'd love to see how others mod it. I keep both my gain and...

Hi all, I'm tracing a few schematics and noticed something about the TS schem that I can't figure out. In the schematics of the TS...

Thank you so much for writing that out. I'll check out electrosmash, and that freq analyzer site is awesome!

A lot of it comes down to: -high frequencies go right through a capacitor, almost as if it was a short. -low frequencies see a capacitor...

I'm trying to understand more about what gives certain pedals their freq response. For example, I really want to like my Distortr for...

You might also try cleaning this thing, as it goes from the LED that connects to pin 2 of the IC to somewhere

Verify whether you are getting something closer to VCC or VREF at pin 1 of the IC Reading thru your volt findings, if you compare pins...

It seems that pin 2 of the IC, or something connected to it, is contacting ground. This would make it so one LED is constant on while...

Yes, the rotary switch is set up such that in position 1, no voltage is sent to pins 16, 17, or 18, and none of the other modes are...

I think it'll be ok. There's a lot of room in the 125b enclosure. I could probably squeeze this into a 1590b, but I like to keep the...

Perform a visual inspection of the IC and note back about what you find.