djmiyta

glad to hear that since I had no luck with both the pearl flanger AND the Boss bf-2 which I etched from other's layouts with no luck...

I can't seem to find any 25k trimmers for this build ( so far). Can I get away with using a 30 k trim pot? It's the last part I need to...

Is it ok to use tantalums where electrolytics would go, on this build specifically the 1 uf ones?

Got it . Thank you.. That's what I did. For me, DEFINITELY, a circuit needing much more focus on dialing in the trimmers to getting it...

Finally got mine working. Is there a specific order to tune the jfets in?

Yes the orientation is correct. Any way you could point out the bias resistors to be replaced? And possibly the trimmer values needed...

Would it be possible to swap the bias resistors out for trimmers? If so, one would tie 2 legs of the trim pot together and then the 2...

kinda the weird thing cause the lfo seems to be working cause the pots are affecting the rate LED. I thought anything over 5 v would...

By load you mean my guitar plugged into it or a signal put into the circuit? No . That could change the voltage?

what would cause the 78l05 give an out put of 7.5 volts ? I can't figure it out.

Is the Expression Jack wired in per schematic ? No. But it is now and though it works still does'nt seem to be as high gain as you tube...

Awww damn and I've seen/read your sense of humor too But it's too late man I'm down that rabbit hole and I'll find the answers

Thank you for the homework assignment. Never heard that term before but I'm sure there is a whole lot I've never heard before so off to...

Thank you very much your help is very much appreciated . I will definitely check over EVERYTHING again. I have no doubts that you...

I apologize I answered without double checking. No, Q6 is not germanium it calls for it being 2n5457. q1 = 78l15 q2 = lnd150n3-g q3 =...