analog_bham

I use 225F for the drying stage. Just putting a number to it since the “lowest” setting is probably not consistent across ovens.

I also use 225°, 10 minutes for the first round and 20 for the second

I'm realizing that I have overbaked mine. I did more enclosures today and the clear film basically just melted onto the enclosure. I...

That turned out great for a first time. The more you do it the more consistent it becomes.

I use the tip of an xacto knife to get the film started

Thanks for this tutorial!! I used it today for the first time and it worked out really well! I am still working out dimensions/templates...

Couple of fuzzes to report. I finished this one up yesterday and still learning the curves on it. As with most Fairfield circuits, the...

solved!! had wired dc jack in reverse. i overthought it. wired the negative to the positive terminal and the +9v to ground lug. then...

So I have wired up my PNP FF on tagboard but have no sound when I plug in the guitar. I have gotten the audio probe out and it seems to...

Sorry to resurrect this old thread but wanted to just clarify the wiring for a PNP Fuzz Face: As I understand it, I should wire the DC...

I’ve joined the cult! I don’t play much bass, but it sounds nice as a DI with my baritone. Keepin it DIY with some tricky drilling and...

Yes just use a Lumberg. There's no need to use those bulky DC jacks if you're not using a battery.

I have one of those in the bullpen. I'll bookmark @Jachiro's post. Depending on where you need the space, outtie jacks can frequently...

That lettering came out great!

I agree, the lettering looks really good. A low profile lumburg DC jack would have more wiggle room. They cost a bit more, and have a...