huntest

Solder these to the PCB then just stick the components in the hole or solder both?

Thanks, I'll get some. Do resistor, diode and transistor leads fit the holes snuggly enough to make good circuit connection?

Thanks!

I use sockets for my ICs but wasn't aware of sockets for diodes or resistors 😵‍💫

I'd like to but I'm not great at removing and replacing tiny components.

I'm building the Six String Stinger pedal and trying to decide whether to use the indicated in5817 diode or sub in a germanium D9K or...

Thanks

I have my Blue Shoe build just about finished and I would like some advice on how to set the jfets to 9 volts while the pedal is powered...

I may try various different ICs to pick a favorite

I finished my Mahayana pedal and it sounds great BUT the noise floor is a bit excessive. I've read where this circuit is prone to this...

Even if I tried to straighten the legs, the chip is surely damaged 😞

My OPA 2134 IC from Stompbox parts came to badly smashed. I hope they replace it.

Swelchy, Are you referring to the TL072 IP or the TL072 CP for the Mahayana IC build? Thanks

Thanks for all the help, I'll keep working on it

I fixed R102 ..... Still not working. When I touch the PCB on bottom of stomp switch it hums and occasionally pops. Could be a solder...