-
-
NLooks pretty good. You may have noticed that the slots for the switch pins are much larger than the switch pins themselves. Your...
-
NNic reacted to Chuck D. Bones's post in the thread Where can I get one of these switches? with
Haha.
-
NI see some folks in earlier posts are using heptane. Wow, that seems like overkill when IPA does the job fine, kind of like using...
-
NNic reacted to EisengesisFX's post in the thread Rainbow's Ende 🌈 👽 (Rainbow Machine/Leprechaun) with Like.
THE PEDAL As with so many PCBs out there, sometimes you just wanna build it out of curiosity--and not least with something as bizzarely...
-
NNic replied to the thread What can I do with these ICs/transistors?.Aion L4 requires an LM13700, maybe the L5 also ?
-
NI finished this one a couple weeks ago, I'm not quite happy with it, it's rough. It cuts all the signal on the first third of the pot...
-
-
NI see, so run a wire from that foot switch pad to the “output” 1/4 jack, and solder the “ground” pad wire over to the other ground for...
-
NNic reacted to Feral Feline's post in the thread Schematic/Wiring for A/B + C Loop Switcher? with Like.
No problemo...
-
NNic reacted to BuddytheReow's post in the thread Buddy's Breadboard and Circuit Design Notes with Like.
@Sturdag Lagernathy was super cool and designed a PCB for my Nebula Drive. Super cool dude, btw. The board has been verified and I have...
-
NNic reacted to Feral Feline's post in the thread 2 pcbs, order switcher, but ONE footswitch… with Like.
Late to the party — seems it's all covered but here's my stab at at the dead horse anyway:
-
NNic reacted to MattG's post in the thread Tube Bender Deluxe (Chuck D Bones circuit, szukalski PCB) with Like.
Here's my Tube Bender Deluxe. This circuit draws inspiration from the Dinosaural Tube Bender (offered by PedalPCB as the Pipe...
-
NHere's a PCB that's been sitting in my "to build" pile for over two years. Is is the Dragons Breath Boost, based on the Catalinbread...
-
-
Loading…
-
Loading…
