Hey, thanks- I was using the all-plastic Neutrik (apparently switching) jacks for the first time on a Delegate build tonight and I was getting no signal- just buzzing. I changed the jacks to all right side only connections as you suggested, and it fixed my problem as well.
Hey @BurntFingers I just did it, and wow- the distortion is DEFINITELY notably gone or at least reduced to a point where the pedal is certainly usable for the first time and within some normal range of expectation. I can see the led clipping and the output isn't crunching with every single note...
There's no way this is normal behavior- I listened to SS demos and it has nothing to do with the longer delay, which would is understandable.
Here's a video showing the problem. I am playing fairly hard in order to accentuate the problem, but there is no setting where this is not...
Oh for sure I don't think PedalPCB is at any "fault" of any kind. Just the reverse - I think he is a literal hero. And I appreciate everyone's help- I hope to be at a point where I can pay it forward someday. I just keep holding out hope that there is something that can be done that will tame...
Hey @Chuck D. Bones - I checked the V to pin 1 on the socket for the PT2399 and it showed 4.81. Is this an ok value? Datasheet implies it can go down to 4.5. Also --- I did one more test before I was going to try @BurntFingers idea with the green LED (which I will still try) and it was...
Ok so I’ve torn this thing apart and banged my head against every wall—
I’ve:
• Reflowed bunk or questionable joints
• Swapped in/out 2 other PT2399 (from Smallbear)
• Replaced every bit of wiring
• Replaced hardware
• Removed fluxy film from rear
• Added footswitch daughter board
• Prayed to...
So I managed to make a tiny surface nick across a trace just deep enough to take off the solder mask while building a Dwarven Hammer. DMM shows continuity between point above and below nick. Ok to ignore and carry on?
Thanks
I appreciate you taking a peek at it.
I feel like it’s just the silver coating on the pad of the one side that came off. I think the inner plating is still there. I’ll try resoldering to it first and epoxy gluing as you recommend.
2 quick followup questions if that’s ok—
At what stage do you...