So I managed to make a tiny surface nick across a trace just deep enough to take off the solder mask while building a Dwarven Hammer. DMM shows continuity between point above and below nick. Ok to ignore and carry on?
There’s a trace where the scratch is. And it looks like there’s a ground pour around it. Test for continuity between one of the pads connected to the trace and a ground pad. If you have no continuity, you should be fine.
There’s a trace where the scratch is. And it looks like there’s a ground pour around it. Test for continuity between one of the pads connected to the trace and a ground pad. If you have no continuity, you should be fine.