Recent content by Anthonyj

Not sure what killed the 2N7000 but it is working since being replaced, ESD sounds like a possible culprit being in the carpeted basement during the winter. I'm going to try it again with the charge pump later since it's only 4 solder joints to use. Thaks for all the help.

I replaced the 2n7000 with a new one and also removed the power pump since I am using a passive bass and maybe don't need the extra head room. Could the 18v have killed the 2n7000?

So far I prefer the 12n as it keep the low end intact for my bass, I haven't tried it on guitar yet.

Looking through my bag I only have some Jfets I don't have a replacement for the 2n7000. Is it possible I killed it using the charge pump pcb?

D10 is in the correct orientation, and that extra board on the bottom is the charge pump board knocking it up to 18V so it's still true bypass so that signal it good. The issue is just the effect.

I couldn't really tell so I replaced it any way but that didn't change much. not sure if this helps but if I bridge the cap and the pedal gets a signal its fades away slowly when i break the bridge.

So for voltages left to right according to the picture. Leg 1 15.72v Leg 2 7.52v Leg 3 15.74v The continuity around the area seems good other than jumping that capacitor,

Sorry for the bad pictures.

After about a year and half of good use my Lamb Chop just stopped working today.... I did some trouble shooting with an audio probe and the issue seems to be at C1 right in the begging. I have audio on the left side of the cap but not the right (based on picture below), if I bridge the...

I Couldn't find this so I figured I would add it. please tell me if I was wrong. I was on Aion Fx's site and came across the Azure chorus thinking it might be fun since it was based on the CE-2. In the instructions he mentions that between the CE-2 and CE-2b the only difference other than a...

Is it working?

I've had this issue recently, I don't see if there is a led already wired into the fuzz pcb, put one in. When I tested this I noticed I wasn't getting power the effect pcb. I was able to fix the problem by jumping the sw and gnd holed on the bottom and wiring them to one of the grounds on the...

That is awesome, simple and exactly what I was looking for. Thanks.

Morning, I've had this pedal for a few months now and have been really enjoying it and made some changes (Tone mod and 18V mod). the only thing that is bothering me is the "clean" mix knob. I know it's supposed to start to break up in its own way, but with my bass it seems to be breaking up...

Did you get the same LED and LDR that the build docs mention from Mouser? I have to say based on the number of posts/threads this is a bit of a finicky build lol.