Heyo!! any leads on the proper bulb and LDR for this I'm looking at these two from Digikey and wondering if they'll do the job!
https://www.digikey.ca/en/products/detail/advanced-photonix/PDV-P9203/480628
https://www.digikey.ca/en/products/detail/visual-communications-company-vcc/7371/43471
Should preface by saying I've built a few of these and they all worked right out the gate.
This one I'm getting sound up to R8 and Pin 5 of IC1. Tried 2 different TL072 and same issue.
IC3 gets incredibly hot right away. I get some signal on both Pin 1 of the dual gang gain pot.
I'm actually waiting on my shipment of pots and other goodies from SBP. I love the ease of use of the drop down menu to order various values of the same types of pots :D
Hi!
I know there's a lengthy thread about Tayda's UV print service.. I learned a lot from there, thanks to all who posted on that mega thread!
I'm in Affinity Designer. I've taken a JPG and vectorized it to a png in inkscape. I then brought that into AD and converted the image to curves.
When I...
Question about the UV printing from Tayda.
I'm looking to build a Ceasar from Pedal PCB..
I've placed PPCBs template over the Tayda one, and they're a little off from each other. Tayda measures out at 62 x 117mm while PPCB is 64 x 118.5mm
My concerns are twofold, one, properly sizing out my...