Recent content by Cagno

It is an Aion FX pedal. The karkadann Overdrive. https://aionfx.com/project/karkadann-dynamic-overdrive/

I see, thanks again!!

Wow, thank you for that information. HYPOTHETICALLY if there was a capacitor in line with those voltage dividing resisters going to VB how would you calculate that?

Thanks! I'll take a look at that post. How about this given circuit? VA looks like 9v, but I'm not sure how to determine VB

Hey! Recently into the DIY pedal scene and have a question regarding voltages. In most schematic diagrams you see a VA and VB reference point. How do you calculate or find these voltages if the schematic doesn't immediately specify what they are? Are they universal voltages across any given...

Those two resisters were infact 27k, but you're right, R26 was not soldered properly. I appreciate you pointing out my stupidity. Thank you!

I just measured the voltages of both TL072 chips and all the legs that should be 4.5v are double what they should be. The 3rd TC10 chip has the correct voltages. The pots also seem to be getting double the voltage they should be.

Just resoldered. not change. they are definitely making a solid connection. When I touch the bottom of the chip it goes away, and a few seconds later it slowly fades back to chaos.

Okay, so I just found something out. IF a press the bottom of the chip where its legs are soldered to the board, it works. What does this mean.

Currently having issues with my newly built Kliche Overdrive. When the pedal is disengaged it bypasses signal, but it still seems as if its going through a clipping circuit of some sort. And as soon as you engage the pedal it becomes a turbo fuzz face at 100% gain. Not sure what to look for or...