Recent content by Curandero

quick question as it appears you used the dual pot - is there any real benefit to splitting the pot and doing 2x a100k pots?

Poop. Thanks man, I do have some known good of both.

Purchased from tayda… damn - I’ll take a picture when I get home.

Hey everybody! Long time lurker first(or second) time poster. I built an ember boost and when I plug it in/switch it on it sounds great but then starts to do the dub/feedback regen/climb to feedback/bitcrush style noise until it just doesn’t let signal through. Attached is a picture - don’t mind...

Is there a board left? In conus - happy to paypal

Thanks! I hate paying Jeff b. But I’ll have 10 tomorrow…. I should be able to plug it in and check the rest of the circuit while it’s in the air though, right?

I just checked it again with a cord plugged in and it does in fact ground it out. What’s the recommended jack?

I’m about to pull the “electrical tape” trick

Not getting any continuity between the jack and the + on the pcb.

They are on the back side as I didn’t have the right gauge wire to fit through the tiny holes.

Hello! It appears that my Muroidea grounds out when I plug the in/out and engage the pedal. When it’s disengaged - it’s clean as can be! Attached is a picture for the eagle eyed viewers. I believe I’m wired tip - in and ring - ground. When I wired it tip - in / sleeve - ground it when...