Cybercow's latest activity

Thanks for the exact measurements. I've updated the board to the latest. My initial measurements were pretty close (probably close...

Another note: For those interested in doing one full up vintage-style with wire wrap posts, I found that the Vector T46-5-9 is fairly...

Got a link to the inductor footprint I made for kicad right here. Only caveat is I haven't checked it against the RM-6 footprint of...

TBH&F, I found a LOT of them for cheap years ago before the prices went up and got quite a few. And considering they were stated as NOS...

I had to procure dozens of the 2N4399, 2N4398 & J201 JFETs to find the right ones. TTH 2N439x FETs are harder to come by and the SMD...

If you also want a CHORUS effect, any Small Clone chorus circuit will dial in a valid X100 chorus effect. The original ECHO effect is a...

Any 2N4399, 2N4398 or J201 will work, but it needs to possess a specific Vgs(Off) value of -1.0V @ ±0.10V ; preferably ±0.05V, for it to...

The Proposition would be the best option offered here. It doesn't have chorus or echo, but neither did the Sustainor.

This is the way . . .

D1 and D2 clamp the signal in between the respective voltages. Typical use is to protect the input of digital chips from voltages below...

Here's a close up of a section of one of the diagrams from the first post in this thread. It's the X100 Mode switch mapping. It's what...

PPCB has no full featured X100 project board. As @MarginalPlayer points out, PPCB's "Proposition" is a buffer-less Rockman Ultimatum...

When I drill tayda enclosures I just go ahead and tap the screw holes now at the same time. Just saves me taking it back down to the...

Use the IN/OUT at the top of the board, these won't be attached to anything else. With the footswitch attached at the bottom you'll...

Yes, the Auditorium Test Platform, it's great for testing, helps so much with troubleshooting if you know your board is fine you can...