Recent content by dcfvgb

Great build, love all the old school looking parts

It is july, so ya, merry xmas in july everyone!

PCB guitar mania, and it works? Great job on the graphics!

On my build IC4 pins 6 to 7 measure 79 ohms, so that's normal. I just reread one of your posts, my bad, I meant continuity on IC5. Ok I have my pedal/schematic/layout in front of me. Turn depth all the way up, and IC2 (randomizer) pin 5 clock signal should be seen at IC5 pins 1,3,6,7 and IC6...

Could be. Either found a box buried in old stock or waiting for a good time to unload.

Ya me too. I can get 10 smd for less than the price of one TH. It surprised me that someone was making them again

Was looking to buy some smd j201's at digikey and TH j201's popped up for 7.49 CDN each. Where have I been?

looks great

love the graphics

continuity check the traces around the lm258 to other parts of the circuit. some ppl have had traces break.

You can test the randomizer (IC2). Multimeter set to DC, measure pin 5 to ground, it should ramp up and dwon somewhere arounds 1 to 3 Vdc, faster and slower by changing the rate pot. If it works, measure the BBD pin 2 or 6 AC to ground, should see around 10 maybe 100 millivolts ramping up and...

Which drilled (drill file) tayda enclosure would fit the Golden Falk OD?

I've built two, fantastic phaser. I used a pot dustseal to cover the opto LED. Love your colors/graphics

That looks fun!

Great old school look