Recent content by delayed

I do appreciate the posts. Thank you!

The left two and bottom pads are the same per my meter. And the right top and bottom pads are the same. I was guessing the top marked primary is for maybe a Fasel inductor or 42tm014 type. Both of the above picks shows the prime dot on the bottom right.

Any chance the primary dot on the coil matters which side it mounts to? Looks like it should be on the left side technically if I am reading the schematic correctly. Using the me6.

Thanks I will look into that. US.

None of those voltages are fitting in that space. Thinking 12v or lower maybe. Just wondering what other people used before some off board wiring takes place. :)

What voltage should the 470 and 220uf be? The ones I have are way too large for the area supplied.

Hi all, I am building a conqueror fuzz for a friend. Having a bit of an issue finding the BC548. Is there a sub NPN that will sound the same? Would the BC548b be fine? Or something else that is closer? Is this just a jellybean type and any simple NPN type will be okay? BC547, BC549, 2N2222...

Here is a gut shot of an older tim

Does anyone know about the tremolo box in the ampeg Gemini 2 g15 (TM1 Tremolo unit). Is it just a neon and ldr? Curious why it is so large. Looks like both powers are coming off 12ax7 plate voltage lines. V4 and v7 Schematic looks like a neon but the other diagram is a bit different. If it is...

Here is another PCB for your data

Anyone have a MK50240 ic or direct drop in work alike?

Can anyone tell me if r78 in a line 6 M5 is o ohms? 0805 0 ohm resistor 1/8

Could cut out the high voltage light inside it and replace with a led

1 vote for using it.

Thanks for the update