delayed

Trim pot. Then adjust to your preference. Or then measure the setting on the trimmer and install that resistor.

I figured it out. I took your drill file and scaled it properly in Corel Draw and then tweaked the water slide decal to proper measurements.

Yes, it'd be great if someone created a theremin PCB that could be used for real music like a Moog Etherwave or Claravox. I think it'd...

You can test the ic socket for a bridge or if it is making contact with the PCB by taking out the ic and using your meter to see if the...

Have you tried swapping around the Bbd yet? Or measured the empty sockets before installing them?

Did you get the echo ic from him?

I was saying a good first step would be swapping the ICs between the two pedals to confirm they both work. There are plenty of fakes for...

If you have a working one you can compare the volts. Have you swapped the BBD ic? The text font looks a little different.

Glass bead kit, or some glass rods might be fun for you.

Is the diode in the wrong direction bottom right?

https://on.soundcloud.com/e99DZWrw1iLEscec6

What's a buffer? In the simplest terms, a buffer is a circuit that amplifies the current, but leaves the voltage unchanged. The perfect...

Any tips on components? Or anything odd about the build? This pedal is up next for me.

That’s a 4u7 (not a 4n7) you’re looking for. Should be available from most online electronics stores.