Hey man, we got it working!
The PF5102 in Q5 (which I replaced with another PF5102 at one point) needed to be replaced.
I replaced Q5 and it kind of worked (It sounded like a TV tuned to static) but when I replaced both of the PF5102 (Q1 & Q5) that fixed it.
I guess all the PF5012 I got were...
Sorry for the long reply!
I put together a probe and here is where I think the issues is.
Filter Pot - Working
R24 - Working
C19 - Working
C18 - Only the bottom works (Replaced, same result)
R25 - Only the top works
Q5 - Only the pin all the way to the right works from the component side...
Hello all,
First off, I greatly apologize for coming here again for the same board.
1- History: I bought 4 original boards to build. I built one and had issues. So I came here for help but eventually gave up on the build ( I will detail the issues later ). The three left were graciously...
Hello all,
I am building the Triangle version of the Muffin Fuzz and am having trouble finding two parts.
50nF and 4nF capacitors. I assume they are box film crossing the circle like the rest.
Even Mouser doesn't have them : (
Side note, on the iron side I like to put the corner of iron tip into the hole as much as possible.
On the rare occasion that I just can't get the solder out I use a Thumb Drill to carefully drill out the hole...
This one is INCREDIBLE. I hated hated hated solder sucking but this makes it not bad at all.
The silicon headpiece is great as you can jam it in to all sorts of hot places...
Ahh, I normally go over my resistors but didn't this time till you mentioned it. I found a mistake early on. I had a 22k in a 360k slot. I don't have any 360's only 330 and 390. I put a 330 in there and it is more up to volume. When I get some 360s I will swap it out. Thanks!
Hello all,
It's your favorite idiot again. I just built a Seabed Delay and it is super quiet. I compared it against a Disaster Report Jr.(I built) and a Dispatch Master and it is much much quieter. I replaced the TLO72 with a OPA2134 to try to help. It sounds a touch better I think with less...