Recent content by Discobungle

I have a pedal that I designed and built using strictly point to point for the circuit. I want to have a pcb version made but have no idea where to start. Is there a service for that? Someone designing the pcb from a schematic and enclosure size?

I changed to a C pot and seemed to fix it basically.

So I’m using a 5KB pot for the fuzz control in my pedal and the fuzz really only kicks in around 9 or 10 on the sweep. Before that there isn’t a whole lot going on fuzz wise. Any suggestions? Would a 5KA work better or a different value?

Thanks for all your help. Works and sounds great now.

So after a lot of searching, I think that music6000 is correct that I have the E of Q2 connected to the wrong side of the 100k resistor. I'll change that tonight, Everything else looks correct. Thanks for your help guys

I see that now, thanks!

The Q1 and Q2 orientation is the way it is because of the limitations of point to point. I couldn't really do it the other way around

Sorry. I didn't get notifications for all of the responses. I'll work through them today and respond. Thanks so much for the time ya'll are taking to help me out.

I’m also getting continuity between pin 2 of the 50kb and ground. No idea where that’s coming from. Changed the 3PDT wiring a bit too. Here’s a pic.

I checked and I think it’s correct. E of Q1 goes to ground. B goes to C2 and 100k and C goes to B or Q2 and 33k. Here’s a more clear pic. I did switch Q2 around earlier though.

I also noticed that my Q2 was in backwards. Fixed that but still no effect signal.

Yes. My take on the Fulltone 69 with an added bias control.

I really appreciate you guys taking your time to help me out with this. Attached you will find the schematic and the transistors that I used are NOS Fairchild, 2N2926 NPN silicon. Thanks again.