I solved the issue on mine, i think one of the legs of the photo-resistors didn't seem to connect with one of the pins of i think q9. I soldered a wire between the two points and voila it worked. I just have one other small issue now that there seems to be a tiny little bit of overdrive when the...
i've done all of the above, i did use 2.7k for R14/R15 because otherwise the lamp would stay on.
However, when the pedal is turned on there seems to be a VERY SMALL OVERDRIVE effect on i'm talking just barely. It doesn't matter what the output volume knob is turned to. Any idea what it could be?
Would anybody be as nice to point these out on the mini-board? So far i can only find documentation about the large electrovibe.
Thank you SO MUCH in advance!!
R4 - 2M2 - Unity vol mod
R12 - 5M - Slow speed mod
R14/R15 - 2k7 high speed mod
C10/C13/C15/C21/C23/C24/C26 - 10 uF - Low end mod...
Hi i have two small questions regarding the sandspur/sunflower:
- What is the point of the R3 (1k) resistor? I haven't seen this in the original pedal, nor most other fuzz-faces. Is it to buff up the signal because the sundial is only 5k? I plan on bypassing this with a jumper-cable and using a...