Recent content by ferdinandstrat

  1. F

    Depot Fuzz (EQD Terminal Fuzz)

    Hey dude, I built the pedal with the 4n7 and it just sounded off, weak and lacking gain all around. Switched the 4n7 to 47nF like DigitalZombie suggested and pedal was brought to life
  2. F

    Using the taptation chipset to add tap tempo to FV1 delay

    I thought about the multi delay chips offered here It would be nice to have a tap tempo delay that doesnt make me jump through hoops like that
  3. F

    Using the taptation chipset to add tap tempo to FV1 delay

    PT2399s have 600ms of delay, the average delay time of a FV1 is what? 1 second?
  4. F

    Using the taptation chipset to add tap tempo to FV1 delay

    OK so as you know, the FV1 delays use 100K pots and the taptation uses a digipot instead of a regular pot on the PT2399, which acts as a variable resistor. Is it possible to implement this into a FV1? Instead of programming each delay to have tap tempo
  5. F

    Twin Face PNP Biasing

    Actually there's another option: You are most likely using PNP Germaniums right? Well they are incredibly sensitive to heat. It happened to me too, I built a PNP Germ Fuzz Face and suddenly it sounded splatty and....crap, checked the voltages, pot vaules, tried a 500K bias pot and...
  6. F

    Delegate compressor charge pump whine

    Hardy fucking harr
  7. F

    Delegate compressor charge pump whine

    I use Nichicone electrolytic caps
  8. F

    Delegate compressor charge pump whine

    I cant say for sure about that...all I know is I tried a LT1054 and it whined even worse, when I tried it I made sure to bypass the link between pins 1&8 though
  9. F

    Delegate compressor charge pump whine

    Nope, I use a Strymon Ojai which is supposedly isolated and I only powered it up
  10. F

    Delegate compressor charge pump whine

    So I built the Delegate and I tried TC1044SCPA and 7660SCPA which were both aquired from Digikey, but they both whine for some reason. They emit a high pitch sound, almost inaudible but quite annoying if noticed Anyone know a fix for this?
  11. F

    For those who use the SpinCAD designer - How do I use the Tap Tempo block?

    So its an incomplete block? Or do I just hook it up instead of a pot? Is there something that should go between the two? I am sorry for the barrage of questions I am just a total noob.
  12. F

    For those who use the SpinCAD designer - How do I use the Tap Tempo block?

    I thank you quite a lot for this...but sadly it doesnt tell me much, I am not too familiar with the source code itself
  13. F

    For those who use the SpinCAD designer - How do I use the Tap Tempo block?

    I tried hooking POT0 to the control input of the Tap Tempo block and the Tap Tempo out to the Delay Time of a Delay block and I get nothing, any ideas?
  14. F

    Error connecting CH341(-1) With the Dev Board

    So I installed all the drivers, multiple versions of them in fact and still this error occurs. It is driving me nuts. I connected both the 9V power and the USB
  15. F

    Covert overdrive sounds not only woolly....but unbiased

    As far as I know the only values that were different were the 2M2 voltage divider resistors for the last gain stage I will measure the voltages for the sources and report back
See more
Back
Top