Fingolfen

There are two mounting screws that run through the eyelet board, an insulator board, and into the chassis held in place with keps nuts.

I'll third Precision Design - check out this amp faceplate!

I can vouch for Sandy's work, she's great!

https://www.precisiondesignin.com/

Decided to give a face plate a go. Turned out pretty well (besides being lame at naming pedals). It's a Sanguine Distortion (Revv G4)...

I've only ever used it for details:

I believe this is the board that @Guardians of the analog traced that EL finally put the board out for. I haven't confirmed this yet...

Don’t let them give you any shit about your ponytail, either. Well done young man 🤘

In terms of DC jacks - I use a lot of these: https://lovemyswitches.com/lumberg-switched-dc-power-jack-2-1mm/ If you're looking for...

Im still pretty new to this amazing and addictive craft, but this is one I think came out pretty cool. First off I really dig this...

After using a zero fret on my Meteora build, I’ll never go back. I cut a brass shim to fit behind it. Original plan was antique...

At long last, the candy green I've been begging Hugo about for years is now a reality...

Wow, that metallic green looks really good. Will save those for my next order. I just recently got my two metallic enclosures. Metallic...

Because of the mid control? Does it scoop or just go flat?