Recent content by fontoponto

I use Sparksfun stuff https://github.com/sparkfun/SparkFun-KiCad-Libraries it has a lot of switches in it.

About the Acrobat -> bump :-)

Hi Tomi, yes its working. I could cut the connetions to pin 2 and 3 of U5A as they are on the backside of the pcb but I really don't want to, only if some one tells me that it sounds dramatically different. R41 is 180K on my pcb. Only R16/17 is different from the BYOC schematic.

Finally

Crazy!! In a good way!

It‘s done! Had to go to reddit for Karma farming and try to fish for compliments :ROFLMAO: This time everything is on a separate pcb and in a big 1590X enclosure. Baja Reactor, Unicab and the TPA module each fit in a 125B. The headphone amp should fit perfectly in an 1590A. I used Kicad to...

Cool, let‘s build a club :) Oh wait this already is a club. The unsatisfiable builders.

Woops you are right. This is the first picture of the status after I soldered it. Before the first run. Transistor and IC not plugged in...

I did not use pcb spacers so the pcb is held by the pots and the switch. The pedal is for home use so I think that is ok.

As mentioned in the Wrecking Ball thread, now it is really finished. I went back and forth a with a few different resistor and cap values and went back to stock except for R15 for a better presence control. I bought the kit at musikding and a glow in the dark enclosure at Tayda. It took a while...

Ok I thought a solution would do it. Marked it.

It works. New installation, same DRC settings -> great

May I ask for a "mothers rotten vagina" muff?

YES! I alwys run the checks on the schematic and on the pcb multiple times before sending the files to jlcpcb. Solved my huge mind numbing problem https://forum.pedalpcb.com/threads/aion-redschift-madbean-kezuroukai24-selfmade-pcb-issues.25482/#post-324524 But I have to admit that I would have...

Solved, two not connected GND pads.