Thanks for the offer man, I really appreciate it. I did already order what I needed.
It's still not fixed and I understand the lack of warranty on their products but it is ridiculous that you cannot get in touch with anyone over an issue like that and whoever owns Pedal PCB expects the...
So the bandwidth knob on the build sheet is just missing, nothing there. It says A10K on the board but nowhere on the build sheet. Of course, when I go to contact PedalPCB it says "please post in the forum" so no real customer support either. I ordered my components based off the build sheet...
Desolder wick works very well for this application. Better to do it right than to Jerry rig it and have issues.
When I first started soldering I was also horrible at desoldering even with wick. A couple of tips 1) use relatively thin desolder wick for these small parts. Too thick and it could...
I am ordering parts for my Tyrian Distortion right now and am looking at the parts list and cannot for the life of me tell whether to order a film cap or a ceramic cap. I can tell when it is an electrolytic cap because they are clearly marked on the board and polarized.
On the Tyrian it looks...
Alright folks. IT WORKS! Holy crap thank you so much to all of you! I did not have the pad under the IC2 soldered and I went and picked up a TL071 from my local electronics store and 5 minutes later viola! It worked! Thank you so much for the help this pedal is awesome! I will have to post...
Let me start off by saying hello and that I am new here. So, Hi!
I purchased a RullyWow ChuggaPre PCB (I know it isn't PedalPCB but they were out of stock and I have bought a few from PedalPCB but haven't started them yet)
I built this preamp and it works in the sense that it boosts the crap...