Recent content by harryl32

Yeah all resistor values are correct. I'll unsolder and tidy those wires up when I solder leg 1 of the pot to ground. Also I didn't use any flux when soldering I think those patches are where the plastic has melted a little bit or the solder has spat. I've also attached a picture of the back...

Hi, I'm getting continuity on all highlighted points as well as the right colour codes. I will say however, while R16 is the correct resistor at 20K, my multimeter is reading 6K instead which I found pretty weird.

Thank you very much for the reply, I won't be able to solder until I'm back at work after the new year but I'll try that solution and get back to you when I can. I'll check continuity and resistance soon.

I seem to be getting quite a “hollow” sound from my Triangulum boost and I’m wondering if anyone has encountered this problem before. Also I’m aware of the bad solder joint on the pot, the pin is soldered to the pad on the other side of the pcb.