Recent content by Haz

https://forum.pedalpcb.com/threads/cornerstone-aquarium.12471/page-3#posts

Hi, yes total amount is big sure. But Vibe with LFO promised prob. 2 years ago.. Tilt Drive I posted gutshots, not even a tilt part of this drive. Fun is not making some random neverheard pedals. But some of theese that at on the wishlist.

Hello all Is pedalpcb still in active developement? It's been such fun of getting pcb:s of pretty new pedals and try and tweak them. Visited pedalpcb daily whether a new board will pop up😍 For a couple of years this was pretty stagnating... Waited so long for promised vibe with all bells and...

Can somebody tell if 470pF at C8 is correct? I get no signal after it. Swapped another 470pF but no luck. If I short it I get pedal working but only halway working treble.. Thanks!

How it the sound?

Yes they exist but I've got 0 support for the used pedal. Nobody replied my emails. Lucky me it was a single component issue so fixing that got me a working pedal.

I've managed to get friends functional pedal and poking with a scope in both I've found out that one of the fets was shorted on mine. Replacing that fixed the problem!

Voltage doesn't drop on lower board even if both boards are connected. I get 50C degrees on LF33, It's outputting steady 3.3V so I guess it is normal operation. Otherwise no hot components.

Can somebody tell where to look for a problem?

Hi! I have this pedal with an issue of dropping voltage. Is has multiple voltages inside, 3v, 9, 27 volts. 2 boards interconnected. When I separate the boards, lower one with powersupply holds voltage ok leds on bottom board are working. When I connect upper board, voltage drops in 1-2 sec and...

I have to admit that turning over the cap and reflowing joints didn't help. Still sound is weak. I measure around 80hfe on OC71 maybe that is a culprit? Edit: There is 1uF cap instead of 1nF🤣🤣

Replacing chip didn't help in my case

Hi, I've got same issue with no gain and low output. I'tried different GE PNP from 80 to 150 hFe with no luck. Different transistor and charge pump. I have pin 1 and dot down right, continuity to R10 and R11 are fine. Other pins to ground and to pot are fine. Any clues how to make this work...

Hi where I could find out about bass mods?