Recently built a Leprechaun. Whenever I hit the Regeneration switch and turn the Regeneration pot up a bit I just get feedback.
I double checked the expression jack, which is correctly wired. Also re-flowed the FV-1. But I cant find a schematic so further troubleshooting is dificult.
Any...
You need to either check the datasheet for your jack to see which pin is attached to Tip, Ring, Sleeve and Switched Tip. Alternatively you can use a multimeter on continuity mode to figure this out:
Connect a TRS cable (aka. a stereo cable) to the jack. Using the multimeter find out which pin on...
Thanks for the feedback!
It is definitely going to very cluttered when done. Hard to cram all that text into the surface of a 125B. I hesitate when it comes to the numbers on the rotary switches and the table. But then again I would really want that info when using the pedal.
I sprayed the...
Just made a design for the mini heterodyne receiver (which I am yet to build since I lack a few parts). I´m not sure if the labels on the switches are correct though (the labels on the toggle switches for root and the table for the rotary switches which I got from the EQD original). Can anyone...