Recent content by KindCanuck

Scabbard schematic?

Still looking for the Scabbard Schematic for my build

What circuit are you asking about?

When I built mine, I just used the separate build docs of the Sproing and the Moonshot Tremolo. This is a little more difficult but it'll get you there :)

Trying to troubleshoot my Scabbard build, and I need a schematic to help me probe it. Any luck, @Robert? Thank you so much!

Thank you!

I'm adding a 9v out to the back of my amp to power my always-on reverb pedal that will live inside it. I never adjust it, so it's taking up space on my board, why not free that up and give myself another project? The amp is my SLO-30 Clone I built last year. Here's the schematic I've come up...

https://www.rosamp.com/wp-content/uploads/2022/09/SLO-30-Schematic.pdf That’s the Rosamp schematic, you can see the loop’s values on it.

I actually love building amps more than pedals, lots more room to work with and lots of wire to route :)

I FUCKING GOT IT. One (or maybe both) of the 10uf Tantalum caps was toast and not passing the LFO to the lamp circuit. It's happily pulsing next to me as I write this. I'll box it up and post pics tomorrow :) Thank you to all @Mcknib @neiltheseal @Diynot @Robert for the tips, it really helped...

I verified all the components, all are correct. I may pull the other 1uf ceramic caps to put some electrolytics now that I have some, space permitting. I verified the voltage at both middle pins of the speed pot is varying as I adjust, though it is a static voltage. Where should I measure to...

Thanks for the reply, all values appear correct :( This is fantastic! I was looking for an article like this, but google was feeding me forum posts with less than technical replies. I appreciate the work you put in to the reply. I'll get back to you after I've done some more investigating...

I'm dying here. I successfully built an Abyss that's filling the vibe void, but I'd really like to get this going. Any ideas? Bueller?

I'm using these component numbers though the actual layout is slightly different on my board as you can see in the original pics. What are correct voltages for the 5088s? These are the readings of the bottom board's 5088's: Q1 1 - range from 4.5ish to 8.5ish 2 - I'm getting anomalous...

After writing I'm going to clean more flux, but here's where I'm at right now: The bulb doesn't flash, so I assume it's the LFO not passing signal. Both Depth and Rate don't function. I can produce modulation by closing/opening the case, so the LDR's and rest of the circuit works. There's a...