KR Sound's latest activity
-
KR Sound reacted to Nic's post in the thread Can someone help me understand the lugs on this input/output jack? with
Like.
That sheet says 1 = Sleeve, 2= Tip ... should work -
KR Sound reacted to Harry Klippton's post in the thread Can someone help me understand the lugs on this input/output jack? with Like.
Do you have a multimeter? Plug a cable in and do continuity checks
-
KR Sound replied to the thread Can someone help me understand the lugs on this input/output jack?.I’ve connected to the tips in this pic. The other is the sleeve and the back is the ground, natch.
-
-
KR Sound reacted to MichaelW's post in the thread TUTORIAL Basic fret level, crown & polish made easy (picture heavy) with Like.
I've only used the offset z-files. I think give you a bigger range of frets to work on and also allow you some range of how you like to...
-
KR Sound replied to the thread TUTORIAL Basic fret level, crown & polish made easy (picture heavy).@MichaelW Do you have a preference between the offset and the centered fret crowning files that StewMac has?
-
KR Sound reacted to jaminjimlp's post in the thread TUTORIAL Basic fret level, crown & polish made easy (picture heavy) with Like.
Sean from scarMyguitar on YouTube sent me this link and I got the kit... I also bought a cheap leveling bar from Amazon as well was...
-
KR Sound reacted to MichaelW's post in the thread TUTORIAL Basic fret level, crown & polish made easy (picture heavy) with Like.
Do you have a Fret Rocker? That's the easiest way to check and verify is that 14th fret is high. Irregardless of the hump, there's...
-
KR Sound reacted to MichaelW's post in the thread TUTORIAL Basic fret level, crown & polish made easy (picture heavy) with Like.
It doesn't really matter if you get the polish done well because the end result is the same. The way I've shown in the tutorial by...
-
KR Sound reacted to MichaelW's post in the thread TUTORIAL Basic fret level, crown & polish made easy (picture heavy) with Like.
If you don't have a Dremel you can still do it old school. Even after I use the Dremel I'll do a final polish by hand. You can use any...
-
KR Sound reacted to MichaelW's post in the thread TUTORIAL Basic fret level, crown & polish made easy (picture heavy) with Like.
Crowning Frets Time to get out the sharpie and re-mark the tops of all the frets again. Depending on what type of file you have the...
-
KR Sound reacted to MichaelW's post in the thread TUTORIAL Basic fret level, crown & polish made easy (picture heavy) with Like.
Note the difference of how much material is taken off on adjacent frets. One fret was high and one was low. The whole point here is to...
-
If you’re going to buy bulk, stock up on the E6 series. If you have any oddball values that aren’t in there, then you can put stuff in...
-
Sometimes this forum feels like a kind of peer pressure - if I see lots of builds of a particular circuit with consistent praise, I feel...
-
KR Sound replied to the thread AionFX Onyx / Boss SG-1 Slow Gear with PPCB Intelligent Relay Bypass.Great solution
