Recent content by MaxDB54

  1. M

    DEMO FX to select EEPROM builder FV-1 Programs?

    Is there a website or YouTube video to DEMO the FX to select 8 programs using the EEPROM builder FV-1 Programs available on PedalPCB? I built the Arachnid and I am ready to load some FX. Anyone have any SpinASM favorites they really like so that I can sample them too? Thx!
  2. M

    Increase Pedal output gain

    So parallel 15k's across R20 and R21 would approximately double the gain? If so that sounds like a good place to start! Thx!
  3. M

    Increase Pedal output gain

    OK can you point me in the right direction? Did not think about that!
  4. M

    Increase Pedal output gain

    Anybody have any thoughts on this?
  5. M

    Quarantine Fuzz Build - Is anyone easily offended?

    I'd rather see a PCB pedal of this dang virus then the real thing! I can't wait until the virus is a distant past history event. Pedals are a nice distraction form the current craziness. Looks cool!
  6. M

    Increase Pedal output gain

    I have my 1st successful Pedal PCB of the Arachnid pedal circuit. Thanks to all here who answered my questions to build a working pedal! However I do think the output gain needs increased slightly. It looks like right now it's unity gain. Rf/Rin = Gain I double verified all component values...
  7. M

    Quality DIP Sockets

    Yes that is what I am planning on doing. Thx!
  8. M

    Quality DIP Sockets

    I am going to use a machined 14 pin quality DIP Socket for the 24LC32A on the Arachnid pedal but thinking about using a single leaf 8 pin socket to make it easier to swap out EEPROM's. What do you think about using a cheaper 8 pin socket on a guitar pedal? Am I asking for trouble? Those...
  9. M

    Decent power jack for the Arachnid

    Thx!
  10. M

    Decent power jack for the Arachnid

    Thanks for the heads up! I hope I bought the correct ones...the photo shows the nut on the outside? Plastic 2.1mm power jack
  11. M

    Log taper for 10k mix pot on arachnid build?

    Title says it all: Log taper for 10k mix pot on arachnid build? Thx!
  12. M

    Decent power jack for the Arachnid

    OK so this one will work? Perfect! Thanks for the quick reply!
  13. M

    Decent power jack for the Arachnid

    Is this a decent power jack for the Arachnid? I want something quality but have seen comments on metal jacks shorting to the metal case with the outside metal barrel. https://www.taydaelectronics.com/1614-19-lumberg-dc-power-socket.html Data sheet If this would be a problem any suggestions...
  14. M

    Favorite FV-1 programs

    Sounds nice! Thx!
  15. M

    Favorite FV-1 programs

    I just loaded it into my Spin DEV board and it compiled. Has a nice synth effect! Thanks...nice work!
See more
Back
Top