Mcknib

Just for info https://www.analogisnotdead.com/article25/circuit-analysis-the-boss-bd2

Here's voltages of my working one Voltage in 9.04v IC1 1. 4.36 2. 4.36 3. 3.92 4. 0 5. 4.34 6. 4.32 7. 4.38 8. 8.72 IC2 1. 1.61 2...

If your in Europe I'm in Scotland I don't mind sending you a couple think I had around 400 last time I looked so I can spare a couple...

I was going to suggest what @Robert said but for enlightenment here's an old schematic that shows what looks like the DPDT connections...

I've built two boards without issue in the past, and I decided to take a gamble and build a third because they are the only option🤷‍♀️

I use this for any PCB I'm not a big fan of 3PDT Pcbs so rarely use them (not that there's anything wrong with them) It's basically the...

Yes that's right

You want the FET gates set to about 2 to 2.5v to get you around the sweet spot Set it via the trimmer with speed fully CCW Just for...

Have you tried reflowing the jumper between 3PDT lugs 1 and 6 the reason I ask is I built a copy of the '74 phase 90 on an etched...

A few months ago I bought some Germanium transistors from Guitar PCB, and decided to get some boards as well. I thought, "I love a good...

I used 92 hFE with low leakage for the Crimson drive I built a while ago

SOLVED I took the whole thing apart, followed everybody's advice, put it back together and sounding f'n great! Thanks for the help...

Q1 base looks like it lacks solder As said re bias Q2 collector to around 4.5v ish set the sundial so you get 9v on lug 1 (fully CCW)...

That's a good tip. I haven't added any wires to it yet because the main circuit board doesn't work. Woe is me :) I used the diode leads...

You could add a cut off diode pin on the 9v row in place of the 9v wire to secure it to the DC jack It was more just to share this...