Recent content by Milt_Mason

Here's how I chose to mount everything. I'll probably replace the enclosure at some point and I might also swap in a bigger heatsink. The picture shows how I placed the surface mount JFETs.

...continued from before I ended up adding some standoffs to raise up the lid. It works, but it's messy and I'll probably redo my enclosure at some point. Pay attention to how the knobs connect to the circuit I didn't think it through and I originally put the knobs on wrong. In my original...

I finally finished up my build and it sounds great. However, it was a rough build and I want to share my builds notes. I would strongly suggest the following build changes: Change the value for R15. Don't use 1.5k Ohms for R15. I chose 3.9 Ohms for my build, but 1.5 Ohms should also work. As...

I don't think this is just a build issue. I think there's an underlying problem with the circuit for the improved mixer section. Here are the details: I came here for reviews of the PCB and I ended up going down a rabbit hole. This issues people were having seemed consistent enough that I...