Recent content by mralanmorgan

No worries! It came together nicely. Do you have any recommendations for different diodes?

It looked good so I used it. It worked perfectly. I usually have a hard time with toggle switches lining up right, but this was spot on.

Is this a good template for the Muffinator then?

I used this build as a guide. I didn't need to file the board because I shifted the board to the right and made the pots a little angled. Moving the toggle switch does the trick!

Still not a clue as to what happened to this one, but I just boxed up the second board (Moonshot) and this one's working great. Thanks for your time and support, Robert.

I was even able to get the socket out and replace it. I even went as far as putting a new chip in...bummer.

I pulled both c101 and c5 (the strip had turned red indicating too much heat). There's only continuity on pins 3 and 5 on the tl072 socket. I've been staring at it all day and can't find any grounding issues...I've got another board, but I'm afraid to try it.

Only 3 and 5 have continuity. No other pins have a connection. I replaced c101...I'll see if it works.

Should only 3 and 5 have continuity?

I'll check/replace c101...these sockets are about impossible to remove, huh?

47.3k

...oh, my bad. I got ahead of myself. I'm not surprised, you are correct.

Changed it out with a resistor that read 99.8k. Still no signal.

Same setting of 200k it's reading 9.6

I've got the dmm set on 200k and it's reading 47.0...think this might be the problem.