Recent content by pbliven

Yeah I'm not sure why R3 is there either. I did a sunflower build using this schematic of the Analogman Sunface I found on Greybench Electronics' youtube channel. It sounds great! I did have to switch out transistors a bit, because of the noise in some of them. Because of this I suggest getting...

OK, after looking at the documentation I re-wired the negative wires from the jacks to the spots on the board right next to the power leads and problem solved. I though I could just wire them to the box, but apparently they weren't making a solid connection and then I guess the board was left...

Here's a shot of how the tapers of A, B and C pots work. Black line is a B, and green is a C. Both reach the full resistance at some point, just the C is a little faster to the top.

Just out of curiousity, the charge pump IC makes it so that I can still use center negative power supply, right? 'Cause I have the power supply hooked up that way.

First pedal build ever, so bound to have some issues. When I power on the pedal the led comes on but it gives me the same dry signal, no matter the knob settings. And, the circuit squeals when I turn up the volume and fuzz pots, no real fuzz tone at all. Here is the completed circuit below...