Recent content by rjkuyvenhoven

I just made the R4 18K mod and I'm happy with the results.

Thanks for providing the wiring diagram. Going to be helpful when I get around to building Paragon.

First time DHL dinged me I was caught by surprise. Electronics parts are duty free, so I wasn't expecting any additional charges. However, they are charging GST & PST. Not sure why they ding us for taxes but Canada Post doesn't. Plus DHL charges something like $15 for the privilege of...

Not really sure what is going on here so I took a couple shots in the dark (definitely not my preferred approach to troubleshooting). I swapped out the crystal on the unlikely event a timing issue was preventing the FV-1 from reading the eeprom. No luck. So I swapped out the eeprom socket...

Did not think to check that. No shorts to ground or 3.3v or between pins 5 & 6. Strange. Could the CH341 chip be interfering? I wouldn't think so as it's not doing anything. I did use 22p caps for C9 and C13 as I didn't have any 20p on hand.

Thanks. With pin 13 connected ground, I'm getting audio from the FV-1 and audio goes thru the pedal as expected. So that suggests there is an issue with reading the eeprom. I confirmed continuity between FV-1 pin 14 and eeprom socket pin 6 and between FV-1 pin 15 and eeprom socket pin 5...

Tested my completed FV-1 Dev Board for the first time and I'm not getting any effect on the audio. The dry sound is passing thru fine. Mix knob turned full left I get full dry signal, when turned full right I get nothing. I've tried it with the Spatialist and Module8 eeproms, no luck with...

As a general rule, I prefer to socket ICs and Microcontrollers. So in this situation I would solder female headers to the Terrarium and male headers to the Daisy. It'll make it easy to swap out the Daisy if needed. In addition, it looks like the Daisy is supposed to be mounted on the same side...

Hi! Happy to find this place as I get back into making pedals.

Similar for Victoria, Canada: shipped Aug 10, received Sep 3