Recent content by ryan z

I have given away all the spares now. good luck to all. /thread

Heck yeah. Kurt is a renaissance man. He records a lot of my favorite bands including High on Fire.

Agreed. Those things look sweet and I don't need more guitars

I'm now going for the N.E.W. Apostle and the Brutalist! I told myself I was going to take a break from pedals after finishing a bunch recently. That lasted about a week and a half.

Anyone here tried any of their build? I see they make a 3PDT break out boards to go with their builds but they are expensive. Doe any one know if the pinout is the same as the PedalPCB boards. I rather use the PedalPCB board since it supports solder lug switches and is ⅓ the price...

So far I do. I've only run it through a small guitar practice amp and a bit through a 1x15. For live band situation I intend to run it through rack power amp and a 4x10 when I get one. For the next project I am recording, I plan on running this pedal driven through the practice amp mic'ed up...

Thanks! Found a little letter stamp set at a art shop in San Francisco's Japantown that has become my go to font.

I wanted something for the bass rig in the studio for some heavy tones. Kinda got lazy at the end. I has high hopes for some killer graphics, but it's what's inside that counts right? Hoping to track down some smaller baby blue knobs so it is all matched. This thing is gnarly! Does playing fuzz...

They seem to work! that is the extent of my knowledge of assessing ICs. DM me your address and I will send you a couple sets.

Friends, I ended up buying a set of 10 of these pairs for the Cephid build on Ebay. I just finished a build and they appear to be real (I was seeing rumors of fakes out there.) I am not going to build 9 more chorus pedals. Any one needs some of these ICs? happy to trade for other hard to find...

Super simple mic booster. Thanks for the schematic @mdc !! I need to tidy up the ground situation, but other than that I am stoked, and it works as it should. Next one will be cleaner. drilling holes for the XLRs was a pain on this tiny enclosure. Graphic and naming by my 7YO.

I've got this thing underway finally after findeing the SK170s. Where to you suppose I run that GND to? The tab on the xlr socket, to the enclosure, or to PIN 1?

thanks!!

I got some of these to work on a project and I want to cut into small sections. What is a good way to do it nice and clean? The site says just score and snap, but it hasn't been that easy in my 1st attempt. https://stompboxparts.com/pcbs/strip-board-44x32-holes-1590bb-size/

Saw that thread. Made me glaze over and also happy that this forum is much more inclusive and friendly, instead of bullying newbies. Thank you!