Tassieviking's latest activity

That's actually what I was looking at. I found a schematic for the 6505+ that has 8 triodes in the preamp, that seems like a bit much. I...

From what I have read today they are all closely related along with the SLO 100, Van Halen used the SLO 100 which is what Peavey used to...

Here is a sample of my updated MOD for the Bathtup Reverb. Note that the Dry path stays clean: [This is my original case, not my...

Ok, I'll show my ignorance and say I doubt it would be a Marshall 5150 since that's a solid state amp, that leaves my limited knowledge...

I haven't tried it yet myself but when I do it will be on a new PCB, I just wanted to point out the possibilities that exists with the...

Ooooooooo, I like the idea of turning the Bassdude into a JTM45!

So, in terms of simply bending the pin, that would work well. However, I needed to cut Pin 3 because I had already installed the module...

The Fc of 180Hz has been my favourite for Bass. It's a very low slope but still removes the mud.

So, after a pause to re-do my Bathtub Reverb MOD, I've now integrated the idea above [thanks Mick]. I have adjusted the circuit so...

I don't know if you would need the pentode in the circuit, the 200S had a 6AN8 pentode/triode combination tube after the tonestack but...

A Sunn 200s was probably my favorite sounding bass amp. that one shouldn't be too hard in pedal form either.

That looks like a nice and easy mod, I thought you would like the switching with the DPDT on-on-on switch since it just makes more...

It sounds like you got it working really good Samuel, is there any reason to have C2 so high ? I would have thought a cap to filter...