Recent content by TheToneGeek

I've searched the forum however I can't seem to find the coordinates for the top mount jacks on a 125B. I'm using Tayda's drilling service for a few pedals and I realized the PedalPCB coordinates are published in the documentation. Can anyone assist? Thank you in advance!

Ok. I think I found a difference between v2 and v3. The v3 has a 100k impedance resistor (R20 on v3 schematic) and my v2 does not have that. I'll solder that direct to my output jack and see if that helps anything. UPDATE: I did add the 100k at the jack itself with no audible difference to my...

Thank you for offering your assistance. I opened a thread here https://forum.pedalpcb.com/threads/pythagoras-v2-to-v3-conversions-radium-springs.2575/ about the topic. Interestingly, the board I have seems to have one less resistor than the v3 board? I posted the pic of the v2 documentation I...

Here is the board I received/used. Note: The orange drop is .0022uF per the doc/silkscreen, I just ran out of the nice MLCCs.

Thank you for the quick reply. I printed out the V2 documentation at the time of purchase of the board (Feb 19, 2019). The board looks different from your current Radium Springs 3D pic layout and does not match 100% the v3 documentation on page 1. It looks like there are 6 resistors on the top...

Hello! I finally got around to building the Pythagoras V2 Radium Springs and I have the same hiss and weird (low) mix volume past 2 o'clock issues as other members mentioned. Does anyone have the original Pythagoras v2 documentation and/or what changed between the circuit board I have and the V3...

@Jbanks - I also built a Radium Springs Pythagoras V2 board and having the same weird mix levels past 2 o'clock. The reverb will be pretty decent but anything beyond that will really fade the total wet volume output. I thought it was just me! I'm kinda bummed tho because this was not a cheap...