Recent content by VanWhy

This is the Maniac Flanger based off the MXR M117. This is my 3rd Schu-Tone tone and once again @dan.schumaker knocked it out of the park. Sometimes stacked boards can be intimidating but this went super easy. Great layout to fit everything with 1/4 watt resistors. It was tight but all fit...

Worked like a charm. Just ommited D5 and connected the anode of the bicolor LED to the + on D4 pad. Ran the cathodes to the footswitch. Ground of D4 to ground on footswitch. Just needed to jumper the SW1 pads on the board and we are off and running. Used a trimpot for the overall LED brightness...

Good call. This sounds spot on to me. Thanks for the response. I will post back when I get it built.

You are exactly right. Just verified that.

That's wild the pot broke like that. Is that an Alpha? Great build. Really cool looking layout. Good stuff

I see it as just always one or the other color toggled.

That's what it looks like to me...

Just ordered a Dual Octave PCB from Dirt Monger Instruments. It uses an DPDT to toggle 1 or 2 octaves with an individual LED for those 2 settings. (I plan on using 3PDT). Can I just use a bicolor LED? Would that be common anode or common ground? Would it be as easy as wiring the ground of the...

Another great build. I forgot about these so as soon as I saw this report I bought one.

I really like the Hail Satan pedal so I jumped on the kits Abominable just started selling. There is nothing super special about the circuit. Muff style with LED clipping diodes and a footswitch to activate another set of LED clipping diodes. Its nasty and massive. Fun to play Sleep and...

Update: Turns out the THAT module had the wrong opamps on it. Robert helped me get squared away so now I have a working gate! LED is not changing to red but as long as we are gating that noise I'm happy.

Awesome. I'm going to have to build one of these.

Wow. you are on fire. The red looks hot with the faceplate. Where's the LED?

Interesting. I did initially install the 5k6 in r21 and r22 since I forgot the pre wired LED already had the CLR. So maybe I did something when I pulled both 5k6s. I will check there thoroughly.

I hate being that guy but I'm stuck on this one. I built this up with the side chain passthrough, exactly as shown in the build doc. Populated the board to stock except, I'm using a pre-wired LED that has the CLR built-in so I jumpered R21 and R22 with a 0ohm resistor...