I have a few Reticon SAD1024 BBD, what should i build?
- Thread starter paulbarrette
- Start date
Guilherme Collateral
Well-known member
That’s an INSANE gift man! I would, without a doubt, build a Deluxe Electric Mistress
Feral Feline
Well-known member
ADA ALL THE WAY !
Or yeah, what Guilherme said. Both flangers, all good.
Why on earth would you waste perfectly good SAD1024 chips on a phaser?
SORRY @jimilee.
If you go to Moosapotamus, everything is there for you to do the SAD1024 ADA Flanger.
I'm so jellyesh.
paulbarrette
Active member
I just googled it. I didn’t realize it was so expensive! Crazy. Ok i will investigate the electric mistress.
Thanks
Pb
paulbarrette
Active member
That is a cool site! Too bad he is not making pcbs for it anymore.View attachment 89911
ADA ALL THE WAY !
Or yeah, what Guilherme said. Both flangers, all good.
Why on earth would you waste perfectly good SAD1024 chips on a phaser?
SORRY @jimilee.
If you go to Moosapotamus, everything is there for you to do the SAD1024 ADA Flanger.
I'm so jellyesh.
Pb
Feral Feline
Well-known member
Yeah, SAD1024 that he's not making PCBs anymore, but understandable given how rare the chips are now.
To reiterate Guilherme's post — that's an INSANE gift!
With the Moosapotamus info, you can have a PCB fabbed up for you. I'm not sure if any place does a one-off order:
- OSHPARK min order 3
- JLCPCB min order 5 (but cheaper overall than Oshpark, IIRC)
- ?
If you got 3 PCBs from Oshpark, you could build one, keep the second as backup in case something goes wrong, and I'll buy the third in vein hopes that I'll luck into some SAD1024 like you did and in the meantime it'll make great wall art above the solder bench.
I've seen a Chinese clone of the Moosapotamus ADA-PCB for MN3007, which I may or may not have stashed away.
I have NOT seen a Chinese clone of the Moosapotamus ADA-PCB for SAD1024 — but I'll go have another look.
paulbarrette
Active member
Good point. I didn’t think of getting a pcb built! Great idea. I will research this a bit more.
Thanks
Pb
