Are these 1S1588 counterfeits?
- Thread starter rosssurf
- Start date
Well, I kinda take that back.
I just checked my supply and I still have 6 with a wide band similar to that. But the color is a little darker and the band is further on the end of the diode, almost like a cap. The band on those in your pic almost looks flared out on the end.
I just checked my supply and I still have 6 with a wide band similar to that. But the color is a little darker and the band is further on the end of the diode, almost like a cap. The band on those in your pic almost looks flared out on the end.
Last edited:
MichaelW
Well-known member
They look different depending on the angle of the pic. Sometimes it looks like a blue cap sometimes it looks like a band.
Sometimes it's hard to see the middle band.
This is the only place I will buy them from. I don't have to guess if they're legit or not. Now whether they're in spec or not is a different story.
The only spec I really care about if forward voltage, and every vintage style pedal I've put them in has sounded awesome.
Sometimes it's hard to see the middle band.
This is the only place I will buy them from. I don't have to guess if they're legit or not. Now whether they're in spec or not is a different story.
The only spec I really care about if forward voltage, and every vintage style pedal I've put them in has sounded awesome.
Yep, it's where I get mine. I've got a cache of at least 60 right now, so I'm going to be good for a while.
I use these in any circuit that uses 1N4148/1N914s for clipping. Don't think I'm going back.
Betty Wont
Well-known member
86 cents for a single silicon diode?!?! Y'all are smoking some flux...
Ginsly
Well-known member
I was wondering about this too...
What is the benefit of using these over a 1N4148 or 1N914? Genuinely asking, I'm not familiar with these diodes.
MichaelW
Well-known member
It's called "huffing flux" just for your information.....
MichaelW
Well-known member
They sound different to me. And I like using them in the original circuits that used them. Some old Boss pedals, and TS808's. Oh and of course the Paragon hard clippers.
When I built out my first DS-1 clone (original '81 layout), I socketed the diodes and tried 1N914s, 1S2473s and then the 1S1588s.
The 1588s sounded the most.......musical? - the other two, being played back-to-back, sounded harsh (to me, anyway). I thought I was hearing things, so I went back and tried the 2473s again, and nope - the 1588s sounded better.
I might still 'roll' through some diode types in the future, but will likely use 1588s as my default clippers.
Last edited:
Thanks everyone. these are going in to a "Little Green Scream machine" build. I am excited to use sockets to test different diodes. In the same build it calls for a 1n5187 protection diode. Will a in4001, 1n4002 work the same even though, (as I understand it) they provide slightly less voltage to the circuit? might I notice any difference in sound even through a very revealing BF Fender amp?
Robert
Reverse Engineer
Yes, 1N400x will work fine... I've even used 1N4148 on a few occasions.
Wait, you weren't here for that whole $5 diode thing?
Wait, you weren't here for that whole $5 diode thing?
Last edited:
