SOLVED Electrovibe LFO ground not connected

ftumch

Well-known member
I built another Electrovibe and everything works but the LFO

With some troubleshooting I've figured out the the LFO ground plane is disconnected from the main ground. When powered up LFO ground sits roughly halfway between the 18V and 12V rails. I have continuity on the LFO and lamp grounds:

Screenshot 2026-11-18 at 22.58.52.png

And continuity across everything else, but no continuity between them

I can't figure out where the grounds are supposed to meet:

PXL_20261118_225055920.jpg

Can anyone see what's going on?

(The scratches in the solder mask are from my multimeter probes while trying to figure out the problem, so they came later. They are surface deep)

I've reflowed a load of joints, no chagne
 
The two grounds are intentionally isolated, they are connected by a small trace on the back left side of the PCB.

Look closely for any damage here.

If all else fails you can connect the LFO ground with a jumper wire... I would connect directly to the DC jack if you go that route.

1795046958934.png
 
The backs of your dual gang pots are almost assuredly contacting the LFO ground with another trace, introducing voltage to the LFO ground plane.

Trim a regular pot cover so it will work with the dual gang pots
 
The two grounds are intentionally isolated, they are connected by a small trace on the back left side of the PCB.

Look closely for any damage here.

If all else fails you can connect the LFO ground with a jumper wire... I would connect directly to the DC jack if you go that route.

Oof yeah I can see, it's lifted at the perforation:

PXL_20261119_013516722.jpg

Is there a way to repair it? I have conductive tape. It's just a matter of getting the mask off without destroying anything adjacent

edit: found this


Scrape away the top layer with a hobby knife and plonk a blob of solder on top
 
Last edited:
The backs of your dual gang pots are almost assuredly contacting the LFO ground with another trace, introducing voltage to the LFO ground plane.

Trim a regular pot cover so it will work with the dual gang pots
No mate they're fine

edit: anything touching ground is ground, a short would pull the other trace low
 
Last edited:
Back
Top