Search results

That enclosure looks amazing!!!

Another demo, another board added to cart. Great stuff!

Oh and also I have the Wrecking Ball pcb and all the parts but I’ve been busy for the last few weeks and haven’t had time to get a build in!

I have a Kingsley Maiden D and Page DS which are the two halves of the Juggler 2 channel D-style preamp. I run them into a power amp and it’s actually my most frequently used rig. Takes pedals incredibly well and sounds amazing on its own too. The Dumble thing, when dialed in, is really great!

It’s hard to tell from the angle on the picture but is there a solder bridge between the anode of the LED and the leg of the pot? The LED trace shouldn’t kill the signal of the circuit even if it was broken. How did you go about confirming the wiring to the daughter board isn’t an issue? It...

Love the my little pony Blucifer! My parents lived in Parker for 11 years and I lived there for a few months. Every time we’d fly in and out of DIA I got a kick out of that creepy-ass statue haha.

Look at the comments on the last few posts

https://www.pedalpcb.com/product/pcb409/ This would do the trick if you wanted an actual pcb to do it. You would just put your chorus and delay in a single loop after your dirt pedals that you could then turn on/off with the foot switch. You could also definitely wire up a single loop with a...

Thirded! This is very cool! Thank you!! 🙏

What a cool idea! I really dig all the DIYRE stuff I’ve tried so far.

Oh that’s right, my mistake there I forgot it’s not a rate indicator. Does the voltage to the lamp change when you adjust the trimpots?

Interesting. If the speed LED is pulsing the LFO is working. And you’ve tried adjusting the trimpots? They directly affect the voltage running to the bulb. Can you check for whether voltage is getting to the bulb itself? If you use your multimeter to probe the solder joints on the bulb, you...

The first thing I’d check is the trimpots. Have you tried adjusting them? If you have and still get nothing, you should inspect all solder joints very closely to ensure you don’t have any solder bridges. Do you have a pic of the underside? I can’t tell for sure, but is the voltage regulator in...

I would highly recommend you make a new post over on the troubleshooting section of the forum. Be sure to include photos, preferably of both sides of the board.

You forgot to pair that white washer with an outtie dc jack. It’s lonely on its own.

Cobbler is pretty solid. I did end up replacing mine on my board with a Vox Mystic Energy pedal which uses a nutube and seems gimmicky but actually sounds great. But until I acquired that, the cobbler did the trick for me.

Can we start it retroactively 6 months ago because I’ve had a problem for a while now and my points balance would be absurd 😂

Sounds killer, even through that little SS amp! I especially liked the Jimi riffs in the middle there. 🤘

I use Affinity Designer as well and I dropped $5 on the pedal builders vector pack v2 that has a ton of knobs and all the common hardware. It’s nice to he able to know for sure that your lettering won’t get covered by the knobs you want to use, and other such spacing problems. There are free...

Rad, maybe I’ll pull the two drill templates into affinity designer just to double check. Thanks!!