Search results

I still haven't decided where the Tap LED should go.

This is my project thread to invite comments / mockery *cough* shared laughter or any input readers might deem worth while :cool: Here is my draft graphic of the Effector against the Reverb I have yet to label the three way switch at top left. It will be up-Reverb, mid-Delay, down-Chorus. The...

Borrow my pics as much as you like… since I stole the whole idea from you 😎 But I AM working on a Bathtub mod to use the ABE module! I’ll post if I get it to work.

So now I have to buy an Ambassador board with my next C2CE purchase 😁🤣

Nice work TillMack!! Looks great :) I've had the same trouble, often the pots have a small tab which need to be taken off. I just do it automatically now as I don't like how the tabs tend to skew the pot's alignment. Also, when using a powder coating and face-plate, I would sand flat the pot nut...

I suspect it is because they only need to manage the voltage drop across the resistors which is much less than the 250v plate voltage to ground.

I checked the resistor values in your pictures and they look good. I don't have a Nobelium with me at the moment, but these are some measurements I've taken previously.

Does one of your output jack tabs touch the enclosure?

I meant “Smarter than me” 🤪

Hi Retty, Thanks for reaching out. There are much smarter people who will ask more questions:) Two things to begin with. 1. Please post some good photos of the pcb board. 2. Have you tried swapping out the tube. Any 12AX7 compatible tube will work.

Soo... I've really enjoyed the extra bass response mod for the Bathtub Reverb. I was wondering if anyone can find fault with the idea of adding a bypass switch to remove the reverb module so it acts as a simple tube buffer and gain stage. I was thinking of bypassing from after the C2 (in my...

Thanks Mick. An elegant mod!

I've had success squeezing one of these between the enclosure and the PCB. I do cut the legs off though. https://www.taydaelectronics.com/tayda-500k-ohm-logarithmic-taper-potentiometer-d-shaft-pcb-11mm.html I like the above idea of replacing the xlr trim pot with a pot wherever you want it...

As an update, Tassieviking's idea of 2M resistors accross the switch to pre-charge the high voltage capacitors works a treat. This is the quietest switch on my board.

I ended up getting that RODE branded one and took on the project. I have some Jensen’s on back, back, back order with a hope and a prayer that they come sometime this year. I want to make the most of the time it’s taken to design my UV print and find the parts :) I’m really keen to see how the...

I should have read further down the comments :) The Unagi unit is my go-to, but the guy loved the “Jensen” name. Has fallen through now in any case. I have just bought a FWBIM v3 so I’m selling my nobelium to fund more parts for another C2CE build :)

I’ve messaged the seller some days ago, but I haven’t had a response.

Ahh… cool. Yes, I normally use the E4305 but he really wanted the Jensen name. Nearest I could find in stock with postage to Australia was closer to Au$400 than $300. Not worth it.

Hey Smrtokvitek... I had someone ask me to build a Nobelium with a Jensen transformer... where did you find this almost mythical beast?