Search results

Watch this!:

Do you have another NE555 you can try, a IRF740 & are you 100% sure that is a UF4007?

This is not the first time I have questioned the J201 BA17 in this picture as others have also??? Note the F in Fairchild! https://forum.pedalpcb.com/threads/chop-shop-works-but-no-clipping-drive.20497/page-2#post-260156 This lot from Amazon don't even have an ''F''

I did it once as an experiment, the switch being more important than the breakout board. I carefully cut the Breakout board across the top with a hacksaw so I had 9 individual pieces & removed them one at a time!!! So, 2 cuts in each direction between pads!

I have both Originals & the Super Six Stevie is a better option! & I have built the Super Stevie twice now! The latest is in this thread : https://forum.pedalpcb.com/threads/boss-enclosure-to-pedalpcb-designed-pcb-so-far.21470/ Just change the Volume pot from B10K taper to A10K taper, much...

I also confirmed that your resistor values looked good while troubleshooting at the start of this thread. Have you had a good look at the Solder side of the PCB for a bad joint or bridge, pay attention to the right angle header pins also!

Looks Great! You do realize this is 1/2 a build report, it's not complete without the gut shot! It could be a Mockup! ;)

Good point on the UF4007, I ordered what was on the BOM or I would have used a 1N4007 being the same numbers!???

When your talking High Voltage, Members are weary like myself to offer assistance. Definitely one for Vigilante398 to look at! Could be the 555 timer via the IRF740 if your not getting 230VDC at the cathode pad of D2!???

It's a a matter of different strokes for different folks, I have no intentions of building any of the above listed.

I do that when the knob is stationary! It tends to chatter, the electric hand drill spins way faster and the sandpaper seems to self centre on the knob to get symmetrical circles using one digit on your hand???

I have a 6 knob project coming up & I needed the aluminium on the top of a skinny Black Knob. With my Electric Hand Drill clamped sideways in the Vice with a 1/4'' stainless shaft & various grades of Sandpaper this was the end result. With a careful scalpel, the white pointer paint pops out in...

You need to post shots of the circuit & wiring as this is not built as designed going by the pots inline across the top!

You could say the same thing with toggle switches with Gain options and Clipping options, they Bang & Pop! All the boutique pedals??? do the same thing! Most people accept it or turn the pedal to bypass & switch then turn the pedal back on. I would have done that on the bottom side so it doesn't...

9 - 12v DC is ok, centre negative, At least 400ma!

Congrats!, See how much more space you can get between the 2 boards before it hits the Lid!!

I can't make out the Resistors clearly in the pictures but that is where I would start. That 4th band catches so many people out!!! Click on Bands for 5 Colours: https://resistor.cherryjourney.pt/

Do you get chorus now you have eliminated the touching of the PCB's

Here is the top PCB board with white components highlighted. There are a lot of areas that are prone to touch the bottom PCB with only a 3mm spacer as Feral pointed out!!! This barely fits in a 1590BBS with a 3mm spacer is a bad design. You may have to seperate the PCB boards and nip of all the...

Yep, what's 3K if the trimmer was linear!