Search results

I've been very hesitant. I got some stuff from Poland early on that didn't get hit but nothing since. Some eBay sellers are including tarrifs already. It is noted in the shipping area. Some just won't ship to the US still. I did order $70 of small plastic parts for work from a supply house in...

For ground lift just use an isolated jack and put the sleeve signal on a on/off switch or use 2)3 of an on/on. No need to isolate the signal with a transformer as the next device(amp) should ground the sleeve on the input.

I Fn love the brassmaster. Widely overlooked circuit. Your build does seem voiced differently with the 1815s.

Maybe a knob less or one knob TS style as a boost on the front end? Something stripped down like the love one eternity. In terms of the Kewpie/muff, a switchable sustain would make the most sense. A high/low gain setting.

I'm gonna pace myself. Burst Box thread at DIYSB

Okay. So, resistor in parallel with whichever option is louder. I would just clip it in... Hopefully it wont mess with the next stage impedance or create a RC filter. Not sure what your circuit is...

Reminder: This is the only finger you allow Will to use. Grain of salt is all I'm saying.

A Chtihl! 2cc to every bar inch!

Cost: survive either a IAIGF or a stickman competition. @Stickman393 , we should do a festuvus competition! Oh wait. If forgot festuvus involes poles and the history there. Your people being displaced by poles around the industrial age and all..

Run a large resistor to ground after theouder clippers. You'll have to experiment. Good thing about point to point is you can easily use alligator clips. Another option would be to double up your 914/34As in series and use a larger output volume pot. Either way, you want to match the output of...

See previous post.

Try soldering axials on the component side. I hardly use my bluetack anymore. I bend the cap leads and flip. Do one side and check. Yeah, you get flux on the component side but I don't care. It's called no clean for a reason.

I use EMI and RFI interchangeably as they're pretty much the same problem for me(MRI service). A lot of shielding required and I work with the MR research group at a large medical university in Nashville who's constantly building things to put in the room for functional studies. If you're...

I really think the best way to handle heterodyne is to use charge pumpd that set the fosc via OSC pin and a capacitor. Use sh*tty +/-20% caps, maybe over a couple of values, and no pedal will be at the same fosc. As long as you spec the cap+tolerance to result in a frequency outside of the audio...

This has my blood pressure through the roof by page 3

It's more dialysis and deafness around here...

The JOYO vision has a tri chorus and is fv-1 based, so it can be done. Could buy one and rip backup the eeprom.

https://scientificguitarist.wixsite.com/home/diamond-church-street-chorus Not fv-1, 2399 based For a tri chorus you could try modding a simple chorus patch. Duplicate the chorus twice(3 total) and get the lfos 120° out of phase of each. Then feed the 0 degree delay line a faster lfo, 2x to 4 x...

Par for the course

You would be bypassing the first gain stage and passing audio to the second gain stage through a 1meg resistor. So yeah. Cleanish boost.