Search results

Just joining in on this thread. My Thermionic Deluxe is a little noisy on the BE-OD side. The Dirty Shirley side is dead quiet. My Brown Betty is a little quieter than the TD, and that has a lot of offboard wiring as I added gain pot switching for dual channels. I've added a klon buffer on...

Gudday all. Just a Thermionic Deluxe.

Thanks, I thought that might be the case.

Soooo..... I'm about to test and box this up. Which row is intended to be the higher gain?

BRILLIANT!!!

Yeah, I was hoping that they'd all be in one place given I've made a few Arachnids/Octagons with custom eeproms.

Just wondering if there's a list of the parameters for the various EEPROM programs. P1 is usually "delay time" or similar for the delays, but what about the others?

It's a tayda pre drilled enclosure. I had to open up the program hole a bit to fit the rotary switch, but that was it. The process was: Grey etching primer, Rustoleum glitter paint, Many layers of Lani sealer (diluted 1:1, roughly) to build up the top and base so I could sand them flat Couple...

Gudday all, here's an Arachnid for a custom order, featuring a custom eeprom from here.

I've done it with a two boosts and a rotary - A, B, or A->B. One footswitch for the whole thing but I suspect you want more functionality than that.

Thanks, the board is built and working fine.

Will an LM2936-3.3 be ok for the voltage regulator, as opposed to the L78L33? And can I use DT-38 for the crystal?

Gudday all, Building an Arachnid, but don't have enough 1n914... but I have a metric buttload of 1n4148. Are these ok to sub in for the 1n914. I wouldn't be asking if this was a dirt pedal, but there's 9 of them in the Arachnid... Thanks, Willy.

Is it worth putting the aggression switch to a footswitch, or is there a middle setting that's absolutely a must have?

It would seem fairly pointless to have them both with the same gain available.... but thinking about it you might just want to swap between eq settings...

I sold a few to get a second hand PRS Se. I've got more loaned out.

Gudday all, here's my Brown Betty build, named Brotherhood of Steel. I added a buffer because I couldn't get it to stop squealing, and had to wire a few of the pots offboard due to the layout required for dual channels. It took a bit of tinkering with the gain trimmer to get a good...

I've built a couple of Thermionics, a Brown Betty, and Madbean's one off BE-OD clone. I didn't really gel with any of them yet to be honest, but I've only really tried the Thermionic in a (cover) band situation. They seem a bit one trick to me, even though I did them with dual switchable gain...

Just want to say thanks for updating this. I was as confused as hell.

You send pin 13 of the FV-1 to ground, iirc. There's a 10k at the base of the eeprom that I socketed, ran to the switch, and back again. The switch goes to ground, or to the 10k back to the eeprom. It's 18mm, so a bit bigger I think. Here's the unfinished box.